DENTIFIX MODELLING HR (hight reactive) FunToDo LCD / DLP
Dentifix resin was created following the collaboration with the dental prosthetists and the company FunToDo (resin manufacturing specialist)
It is from this union that was created the resin DENTIFIX the most affordable dental resin on the market!
This resin is perfect for printing related todental applications(Dental models, alignment, contention, crowns, bridges etc ….) it can be used for all other applications requiring a high precision of the model.
- Precision: Dentifix-3D HR modeling resin allows to print models with a very high level of detail and a precision up to 35 microns
- Smooth surface: With a smooth surface and an almost matt and opaque color, the resin Dentifix-3D modeling HT approaches the traditional gypsum
- A color :Carefully defined by the dental prosthesists for a more effective work on your models with less fatigue for your eyes.
Some explanations :
The idea was to create a resin for dental model powerful and affordable !!
The color of this resin has been validated by the Protestists to make the details clear and facilitate the work in the laboratory. The light of the laboratories can tire the eyes strongly when this one is reflected on the model.
The surface state of this resin is very smooth after printing and its hardness allows it to take very important angles to optimize the quality of printing and limit failures when printing dental models.
You could very well create your dental alignment models with this resin.
This resin is compatible with LCD and DLP typde SLASH PLUS – WANHAO DUPLICATOR 7 – MOAI – B9CREATOR – PROJECT 1200 etc …
Dentifix-3D Modeling Product Property:
Although the properties of this table are accurate, Dentifix-3D can give no warranty, express or implied, as to the accuracy of the properties obtained by the use of this product.
Product properties may change without notice.
Application |
Dental Modeling |
color |
Yellow Sand RAL1002 |
Viscosity at 25C |
95 mPas |
hardness |
81 Shore D |
Exposure energy |
18 mJ / cm 2 |
Max. cure depth |
0085 |
Resolution |
0.02 – 0.085mm |
Tensile strength |
45 Mpa |
Elongation at break |
5% |
shrinkage |
<0.2% |
Produktanmeldelser
Ingen produktanmeldelser enda.